NPS 4 1/2 Extra Strong (XS) Pipe
5.000 in (127.0 mm) outside diameter on a 0.355 in (9.0 mm) wall, giving a 4.290 in (109.0 mm) bore and 17.61 lb/ft (26.21 kg/m) empty. ASME B36.10M.
- Nominal size
- NPS 4 1/2 (DN 115)
- Schedule
- Extra Strong (XS)
- Outside diameter
- 5.000 in (127.0 mm)
- Wall thickness
- 0.355 in (9.0 mm)
- Inside diameter
- 4.290 in (109.0 mm)
- Weight, empty
- 17.61 lb/ft (26.21 kg/m)
- Weight, water filled
- 23.88 lb/ft (35.53 kg/m)
- Flow area
- 14.455 in² (9325 mm²)
In NPS 4 1/2 this wall thickness is also designated Schedule 80. That is the same pipe under another name, not a different product — but the coincidence is specific to this size and does not hold across the range.
Every schedule in NPS 4 1/2
Dimensions are given in inches, with the millimetre equivalent beneath in grey.
| Schedule | Wall thickness | Inside diameter | Weight, empty | Water (US gal/ft) |
|---|---|---|---|---|
| Sch 40 | 0.2476.27 mm | 4.506114.45 mm | 12.5418.66 kg/m | 0.828 |
| STD | 0.2476.27 mm | 4.506114.45 mm | 12.5418.66 kg/m | 0.828 |
| Sch 80 | 0.3559.02 mm | 4.290108.97 mm | 17.6126.21 kg/m | 0.751 |
| XS this page | 0.3559.02 mm | 4.290108.97 mm | 17.6126.21 kg/m | 0.751 |
| XXS | 0.71018.03 mm | 3.58090.93 mm | 32.5348.41 kg/m | 0.523 |
Weight is plain-end carbon steel, w = 10.6802 × t × (OD − t) lb/ft.
Common questions
What is the inside diameter of NPS 4 1/2 extra strong (xs) pipe?
4.290 in (109.0 mm). The outside diameter is fixed at 5.000 in (127.0 mm) by ASME B36.10M, and the 0.355 in (9.0 mm) wall takes 0.710 in off it — 0.355 in from each side — leaving that bore.
How much does NPS 4 1/2 extra strong (xs) pipe weigh?
17.61 lb/ft (26.21 kg/m) empty, as plain-end carbon steel. Full of water it comes to 23.88 lb/ft (35.53 kg/m), because the bore holds 0.751 US gallons per foot. One short ton of this pipe is about 114 ft.
Does NPS 4 1/2 extra strong (xs) pipe use special flanges or fittings?
No. Flanges and buttweld fittings are dimensioned from NPS, so NPS 4 1/2 hardware fits this pipe in any schedule. The one thing that does follow the schedule is the bore of a weld neck flange or a fitting end prep, which has to be 4.290 in (109.0 mm) to match.